Hi, i bought the ultimate bundle years ago and finaly found someone to install one of my 3 implants a few months ago, which is the next.
Install went well except that there wasnt any pain relieve wipes so i did it raw and almost pulled my hand away and probably had my hand too stiff but it doesnt seem to have caused issue except that its a little close to the bone.
With hf tuneon my pm3easy i go from ~15.5mv to 13.9mv if i try a lot.
Feedback would be appreciated
Now for the paradox thing, i got a paradox tag i tried to clone onto my chip which seems to have worked as scanning both gives me the same result but the reader doesn’t scan it
It could just be a coupling issue with the reader. Have you used the field detector keychain with the reader to determine the best location and orientation to use your implant on that reader with?
sadly those have been on my keychain for so long that one cracked and the other just stopped working. I lost the card too.
Though the reader picks up the real tag from a good 5-8cm id assume it would be strong enough for me to figure out a working angle withing a few minutes. I’m only assuming though.
Isn’t paradox lf? Are you trying to determine uf your implant is positioned correctly? If so, you should be using lf tune. A voltage drop as you showed means your implant was on the hf antenna not the lf so if you immedoately tried to write a paradox credential it couldn’t work.
but the credentials are already written, the image i showed of lf paradox reader shows both the tag and my implant.
I guess my best bet will be to remake a lf tester about the size of the implant and see if the reader is just really bad at reading small chips
