So my advice should never be taken.
I wasn’t able to get my initial install of the titan into my finger to “stick“. I installed it myself into the pinky side of my ring fingerTip about 45° off.
It rejected and would not seal up over two weeks. I made the sad decision to remove it and wait to heal up.
After a few weeks I decided it was time to put it in. I switched sides on my finger so now it was on the inside tip of my ring finger. Again 45° but the opposite direction.
This time I made darn sure that the hole was big enough and that the titan went in deep enough. Finally after a few weeks of healing it is in and happy to be in its place.
The only problem now that I am having is I may have gone too deep and made some cuts that I should not have, because I have barely any feeling or sensing from the Titan.
So in short make sure you get somebody who knows what the hell they’re doing!