i think i got the card copied - but im not sure if its just the uid as it now matchs the cards uid that i wanted to clone so thats a good thing
here is the info u requested
[usb] pm3 → hf 14a info
[+] UID: 46 FF EE 2C
[+] ATQA: 00 04
[+] SAK: 08 [2]
[+] Possible types:
[+] MIFARE Classic 1K
[=] proprietary non iso14443-4 card found, RATS not supported
[+] Prng detection: weak
[#] Auth error
[?] Hint: try hf mf commands
[usb] pm3 → hf mf cview
[+] View magic Gen1a MIFARE Classic 1K
[=] .[#] wupC1 error
[!] Can’t get magic card block: 0
[?] Verify your card size, and try again or try another tag position
or this
[usb] pm3 → hf mf cview
[+] View magic Gen1a MIFARE Classic 1K
[=] .[!] iso14443a card select failed
[usb] pm3 →
i should also note i did remove the center board on the proxmark so the antenna is exsposed/ closer and i have tried flipping the ring , moving it a few mm away , changing the location orientation an so on
but again hf search i get the uid of the card i wanted to clone now
as far as the info from that card i have no idea how to move it all over to the ring since the card is gen1 and the ring is gen2