amal
August 18, 2020, 12:05am
7
Did you complie for RDV4 hardware? That’s the default, but since you have an Easy you need to config for “OTHER” hardware and compile for that. Check the “platform” section of the advanced config;
# Advanced compilation parameters
The client and the Proxmark3 firmware should always be in sync.
Nevertheless, the firmware can be tuned depending on the Proxmark3 platform and options.
Indeed, the RRG/Iceman fork can be used on other Proxmark3 hardware platforms as well.
Via some definitions, you can adjust the firmware for a given platform, but also to add features like the support of the Blue Shark add-on or to select which standalone mode to embed.
## Client
The client doesn't depend on the capabilities of the Proxmark3 it's connected to.
So you can use the same client for different Proxmark3 platforms, given that everything is running the same version.
It's possible to explicitly skip the Qt support in the compilation even if Qt is present on the host, with:
```
make clean
make SKIPQT=1
```
show original
1 Like