let me know how well it fits and clicks on, I love the cad file to mess around with designs if you don’t mind
Sure it’ll
Have to get transferred over email the forum only allows certain file types
zip it… should work… also I will add .stl and .zip file support if it’s not there already.
Ok updated
First fit will go in about 30 minutes
If it’s good I’ll post and then design coil cover/center piece
Fit was off Bc I reversed bottom screws
Slot has been made re printing
Also I was getting a LF antenna unusable notification with that setup.
I wonder it it was because it bypasses the switches on the back or what???
That looks really good!
Damn. I really have to get into 3D printing…
Ender 3, cheap and runs good enough, been beating on mine for 3 years now with no end in sight
Might need a bit of tweaking, but If you can run a proxmark you can figure it out
I’ll bet it’s what @LndSqd used, maybe a cr10 or an ender 5 but that’s close enough to count
Wow, that’s not even expensive. Last I checked (years ago, admittedly) they run into multi-k$.
Yea, 230ish last I looked, and maybe 50-100 for
Some nice upgrades and you’re good for a lot of stuff
Yeah, I have a Prusa MK2.5S, 3D printers are awesome. Would highly recommend, especially given their low cost these days!
Mono price maker select v2
It’s a great printer with …$50 worth of upgrades and consistent tlc
I have a problem.
1x Ultimaker s5
1x lulzbot workhorse
1x mpms v2
1x printrbot simple metal pro
This antenna mod idea worked amazingly. I used the longer screws suggested, but didn’t end up using any spacers. I ultimately created my own case design to work with the BT module. Here are the files if anyone else wants to do the same. STL, Step, and F3D files are in the zip. I printed in PETG-GF with 0.20mm layer height and no supports needed when the opening is at the bottom. Note, I think the SLT is tilted about 1.25 deg off from flat on the base plate, you will need to tilt it or lay it on that face.
PM3 RDV4 Cover.zip (603.6 KB)