Please let me know when available! This looks like it’ll solve my issue
I think you may be closer than you think. The xAC v2 has a relay built in so you wouldn’t be pumping power into your fob. The fob would still need a battery and you’d need to find a place to put your wires on the switch just like a garage door. The xAC v2 has that jumper for time pressed so the fob would see a 1 sec closed switch which sounds like he’d be set. I think his diagram would let him get two xAC’s also since he’d be able to close the circuit with either relay.
You need atleast 2 relays one for lock one for unlock, the idea was to eliminate the fob battery to.
Hey, just got my xAC in as well as my Next implant (yay! Just need to wait for my tattoo shop to open post covid)
Just wanted to check to make sure I have this correct. I will be able to program both my easy guard push to start and the xAC to the implant? And I able to use my blue cloner to do this?
Should there be anything else I should get for programming?
Your NExT will be pre configured in EM mode
The xAC accepts EM “tags”
The Easy Guard accepts EM “tags”
So what this means is:
Your NExT will simply enroll into both.
The xAC comes with a master disc, hold this to the antenna for ~3 secs then presenting your NExT and you will get red LED (video how to) This is the chip my life video channel, copy of @amal Video, I’m not sure if they are using it with permission , but couldn’t find the original in the DT YouTube channel
EDIT I just realised you are probably talking about the xAC V2, so enrolling (use this video) but the principle will be the same
Then your Easy Guard, similar thing, it should be in the manual, I think there are 2 ways to do it. the best is hold one of the tags it comes with to the antenna for ~5secs it will beep then present your NExT and you will get another beep, wait for it to time out ~30secs and a couple of beeps, check it is enrolled.
The other way is open up the unit and press the reset button, this wipes all enrolled tags, to the begin enrollment again (Best you check this in the manual though.
All that to say, you don’t need the Blue cloner.
Just enroll.
Generally when you own the “Thing” that’s how it works, just ENROLL, unless in an LF system you need to change the mode, ie. from EM to HID…
Good luck buddy
SHOULD be easy as 
1 Like
Thanks! Should I program it before implanting (tomorrow!)
You don’t NEED to, but you could TRY…
just make sure you leave your IMPLANT in the sterile packaging and attempt to enroll it through that.
Don’t be surprised if it doesn’t work with the NExT effectively being in a faraday “tube” but since it is LF, depending on the antenna, you might get lucky 
Thanks for all the help guys!! Will post a video of unlocking the truck soon!
3 Likes
Thanks for all the help man
1 Like
That’s blimmin’ nice!
1 Like