I think that the plain iClass readers are only high frequency. But you can always try the diagnostic card that you got with your NExT.
That’s probably your best bet. I hope that you can get it enrolled.
iClass is on the matrix and it works with the xDF2. So the readers you’ve got at work are likely to read glassies.
Please keep us updated if you manage to get the NTAG216 of your NExT to work.
Yeah,
I would also go with a probably rather than a definitely, even on the same reader, there could be a difference in power output, model version, firmware etc and therefore different results.
I would use the Matrix as a “good guide”, but not gospel, there is a chance of different results.
I have tried to keep the information as accurate as possible within the Matrix, and links to relevant threads where possible, so follow those links and ideally contact the poster to ask further questions if needed.
Question,
How would I be able to clone for example an Iclass to https://dangerousthings.com/product/flexclass/
Because when using proxmark3, Iclass does not have a “clone” option. Is there a walktrough or guide online? Or the commands that need to be used? I am not finding anything atm. i think after this question everything is answered.
Before joining dangerous things forum:
After joining dangerous things forum:
you’ll want to copy over blocks 6 through 9 I believe, there should be a guide on the forum here with the proxmark commands
Result:
Not able to enroll the xNT side of my NEXT into the ICLASS system.
The readers only read HF , confirmed with the diagnostic card. They were happy to enroll my NEXT chip but it would not read unfortunatly. But as I see in the matric , Flex m1 should work to enroll so I will try that next after I got it implanted. Hopefully that will give me a better result.
Screenshot of the reader. It is a bosch Iclass reader
Did you try using the field detector keychain on that reader?
No I did not.
Do you mean to say that a read could be possible but that I did not place my chip right?
I can try it again next week to be sure…
Check the video on the product page to see why this tool is critical for figuring out how to present your x-series implants to readers;
Il double check with the detector to be 100% sure I placed my chip right against the reader.
Thanks for the video explaining it. Il update it next week
So in the end I actually got it to read, bad news is the software they use to enroll their HID Iclass fobs sees the xNT as “unknown device” . I don’t know what program they use but I saw the HID Bosch logo at the top right so it is probably official Bosch software for enrolling HID Iclass badges etc…
I don’t know if the software will read an flexm1 chip or it will also show as unknown. i don’t want to disturb the receptionist anymore with my shenanigans if I don’t know if it will work 
Maybe I should get the flexClass to be sure 
