PinePhone Proxmark case

[DonFire]

@darthdomo

I managed to bork my LF on this PM3 easy due to the USART0 mishap

If it’s because of the USART0 issue and you’re good at soldering (like you appear to be), you could probably replace the entire AT91SAM7S512 chip with a new one and reflash it with JTAG.

@darthdomo

Need to look into getting another PM3 easy in the meantime though, might pick up the one from DT after the holidays.

They’re also available from Aliexpress, and if you know how / have it set-up in linux, it’s not too hard to reflas them using the unbrick procedure with JTAG, or you can follow Amal’s suggested standard flashing procedure found here:

FlexMT HF Reading Issues

I have had tons of problems getting various Easy models to load rrg properly… it honestly takes a slog of different variations to get it working… I have two different Easy models both with 512k and both required slightly different approaches… one of these approaches tend to work; hold button down, power up, keep holding, run pm3-flash-bootrom, once finished, let go of button but let it flash lights and do whatever the heck it wants to do, see if com port comes back eventually, if com port app…

I look forward to seeing where this project goes!