In the screenshots, are you first calling pm3-flash-bootrom then pm3-flash-fullimage? If the bootrom has been flashed, power cycle the proxmark3 (pull the USB cable, wait 3 seconds, plug it in again). After that, try calling pm3-flash-fullimage and see what it does.
1 Like
Hi I have tried without succeeding to get the continuation of the program it stopped so I had to turn it off and try to resume where it left off but tno way see the picture .
what I understood my Proxmark now has an incomplete program
or can I use it as it is ?
How can I see what has slowed down and if so, how?
If it has not managed to get the necessary item in, how
can I remove everything and start from scratch?
Or maybe there’s a way to pick up where it left off?
many questions that you may hopefully have the answer for
regards
sorry no answer need it for the above question i gott throw ./pm3-flash-bootrom
and :./pm3-flash-fullimage
pm3
and now i am att hw tunenow i am
[+] LF antenna is OK [+] HF antenna is OK
both are ok do i have to proceed with the updating the firmware or optional ?
now i am at : usb pm3 how to go on or do i have to exit from the program?
thank you
1 Like
When you first start the pm3 client it will give a lot of diagnostic information. Post a screenshot of that information.
1 Like
thank you for all help. it means that i can quit this cession at that point without harm ?
Yeah you’ll be fine