Well, I was going to answer, but since you didn’t open it up to the floor, I’m not gonna…
By all means… I just figured since they are the ones actually building and designing the stuff
Hmm that’s a tough one. You’ll probably get some collision errors, but the fact that ones an ISO 14443a flex and ones a ISO 15693 x-series makes it less of an issue. I personally wouldn’t do that because I don’t know what payment terminals in the wild would do. You’d think they wouldn’t utilize ISO 15 commands because they’re meant for ISO 14, but they both have 7-byte UIDs AFAIK so it’s all up in the air. I advise against it unless you’re just playing around and you’re comfortable removing the xSLX if it causes trouble
Nope…OK, but just a little
I don’t have a xSLX, but I do have an original Spark (ISO15693), for what it’s worth, it is an 8byte UID (I actually thought it was 7 also, but I just scanned it, with 2 apps…and yep. 8 bytes)
There will be specific readers that you will be fine with, for example, The KBR1 doesnt read ISO15693 and also, if you were using an arduino, that you set up to only read 14a OR 15.
Otherwise, in my opinion, I think they would likely be too close.
However, you know how easy it is to remove an xSeries…
This is also a good option.
OR,
removing the xSLX from the injector, taping it to your skin in your proposed position, do some testing, then “cleaning” the xSLX before implantation
Just my thoughts from the cheap seats.
1 Like
Just be more selective of the training data sets that you use.
1 Like
Not just any personality prototype… A “Genuine People Personality” Prototype.
Share and Enjoy!
1 Like