Performed a self-installation of the Apex Flex Module. I do not recommend ever doing this yourself but I want to share the footage so people can learn if they so wish. Healing well so far, will keep you posted on healing progress 
Flex Module Installation (temporarily private whilst I fix some issues with the video)
The performance range on this thing is absolutely insane
EDIT: Please see below the bits where I went wrong! 
It freaked me out that you used your mouth as third Hand 
and then the finger in the wound 
How is it healing?
Oh and you touched the Implant with your fingers full of mouth bacteria which pushes the bacteria deep in the wound. thatās even worse then just touching the wound
Please monitor it closely and if it shows signs of infection go visit a doctor! Having the bacteria that deep without a wound where the body can push the infection out it can have really bad consequences
Hey, I really appreciate the concern. My hands were throughly washed and the tools were sterile from factory. Used ISO several times during the procedure to clean the tools too. I think I was pretty careful all things considered I also cleaned my teeth and used alcohol mouthwash to try and reduce the risk even further. (However Iām aware that doesnāt make me immune)
I was concerned touching the pin point of the tool making the pocket on anything hence why I used my mouth to hold the end of the tool and ISOād it when I did have to put it down. Lots of things Iād change if I could do it again but this was my first time cutting myself open like this 
and should be my last
Healing well today and Iāve already got antibiotics available should it be required 
And again, anyone reading, dont do this at home, otherwise you have these kind of risks.
I just wish the UK allowed professionals to perform body modifications without sending people to prison
You will not have those risks as much if you work a little more cleanly.
That does not help at all. No matter how good you clean your mouth there will be some bacteria left. You definitely got it on your tools and through the tools on your hand. It does not matter if the tools were sterile from the factory. You contaminated them with your mouth bacteria.
Best luck with the healing!
I get it, thanks for the advice
Question: This thread is already a NSFW-ish, with blood/wounds etc, how about a penis shaft showing the magnet bump?
Itās been posted before, some precious people got offended, but fuck 'em.
They have gone now.
Show us your shaft
If you want to, put it behind a spoiler blur
[spoiler] :eggplant: [/spoiler]
It was very interesting Skin Tunnel
He slipped an xSeries in it
Gosh, first time Iāve heard I was too bigā¦
Cropped it a bit. Bit off center, and points off to the side 
but there it is
Letās make that policy at the very least haha
Sāwhy I figured Iād ask first, just to make sure
Who wants some hole pics? Hereās day 1 2 and 3 of healing my apex narrow. Next time Iāll shave beforehand
This video shows the āpopā as the needle finally gets through the skin really well. Probably the worst part.
Or the most satisfying 
Now you officially have a new implant
Itās a matter of perspective
Well, thereās no pain after the popā¦ At that point, the needle is past your skin and the rest just feels weird.
Then you donāt feel anything at allā¦ But some people will tell you that they donāt want a chip because they fear that they might feel itā¦
My wife filmed it. Glad she did a good job.
She made sure I felt it. She didnāt know the plunger pushed out past the needle, so she was wiggling it inside. I definitely felt it.
Some photos from when I self installed my FlexOne back in 2020. It recently failed and the amazing guys at DT shipped me a Apex Module which I received today and will self install that in a few days!
