Hello is there anyone who have purchased one FLEXMN or FLEXM1 and havent installed it ? and changed mind and wont use it ? DONT WORRY I WANT TO PURCHASE IT FROM YOU!!! i live in Thailand so i will pay postal fees and all. I feel like car without tyres when my chip aint work….
Which implant do you have?
You Probably dont want a FlexMN.
A FlexM1 is a good choice, depending on what you are trying to do?
What are you wanting to interact with?
What reader do you have?
Do you have any questions for us that we can help with?
i have had two flex mn chips they work best most powerfull antenna thats why im looking for it or the other one ,then i have the new version FLEX m1 v2 and the antenna is not powerfull enough for our scanner at elevator, so it makes it useless cause i need to carry key card with me. FLEX MN WOULD BE BEST, BUT THEY DONT PRODUCE IT NO MORE SO IM ASKING HERE, And my next best one would be FLEXM1 but its stock is finnished too. so thats why i ask that too here
my flex mn is broken now cause in massage they tend to push it sometimes, so i dont wanna take it off before i can replace it same time
and believe me i want FLEX Mn so far its best and the location is on my wrist 5cm from wrist to upwards
do you have the “round/disc” shape one or the “rectangle”?
I’m expecting your answer to be the “Round” FlexMN
because the FlexM1 should perform better than the “rectangle” FlexMN
1 Like
Next question,
What is this reader compatiable with?
You are in Thailand correct?
I found a lot of Mifare Classic readers there.
So the FlexM1 SHOULD work.
Since we know it reads MN, deoending on what you have it emulating, it SHOULD also work with NTAG.
Therefore, I have 2 suggestions for you.
1st, and probably best option.
A FlexNT in my opinion is probably the best flex:size performance implant you can get.
2nd option.
You will need to ask @amal or @tac0s if they still have the original copper antenna FlexM1’s
Amal pulled them from the store for fear of failures, however I have had mine for over 6 years and zero issues.
IF they are willing to sell you one, you mighy just need to agree to a no warranty and accept that it may fail.
Mine is in position P1, and it is very good for presenting to readers.
Good luck
2 Likes