i put it on the case
To clarify, with it on the case it is impossible to read?
Correct. I was unable to read my implant with the proxmark with the sticker attached to the case. I tried positioning the proxmark in a few places near and around the implant
Some goodies came today. So far no issues with either proxmark or the flipper. Going to play more with the proxmark in a bit.
edit. Damn, the controller inside this card is dope AF! I do not regret buying the implant!
My antenna is for LF
I need to find a way to get the antenna built by someone so I just do the tuning …
(Any ideas/leads welcome )
Trying one for the HF side is coming, got a cheap proxmark to test a few things … One of them is a smaller and planar antenna. I don’t like it going through multiple vias …
I know. That’s why I said a solution for both sides.
I want to try something along the line of the drv with pins/post/bolt to hold the HF antenna
Need to get an vna and figure out those cool antenna you made
I have a VNA H4 that is a tad wonky I’ll sell you for cheap. 20$ if you want it
I’ll bite if Xemon says no
Just picked up my freshly sterilized pkg. Getting it installed Wed, hopefully without any problems.
Finally I was able to limp to my desk.
I can say this - so far reading with flipper and proxmark rdv4 success rate is 100%. I did 10 consecutive reads per each, with 0% failures.
Was able to read my FlexUG4 with the PM3 on top, so the serial # was positioned over it, like Amal mentioned somewhere.
Once you know the exact single place it works at, it works every time.
Same for me , but now when the FlexUG4 is inside my hand , im not able to read the chip anymore, im able to read the chip with one of my android phones , but it seems not to be detected by any external reader (garage door) or my other phones.
I just got mine put in on Wed, and I can read it while using a MFGC. But It’s going to have swelling etc for a while, so I’m not expecting it to work great just yet.
I am in exactly the same boat here. Mine was installed only a little over a week ago so I am hoping in the next few weeks the problem will resolve itself as it heals and the swelling reduces.
Same boat here too:
I got the flex fun bundle and installed all 3 last Wednesday
The flexEM reads perfectly with both my android and the proxmark
The Apex reads perfectly with both my android and the proxmark
The flexUG4 can be read only by my android, and i cannot find any spot to read it with the proxmark
Is there any trick i can try?
Further up in this thread, @Amal posted a trick. Bottom of the PM3, where the serial number is, is the sweet spot.
I tried that multiple times on and near the serial number, but still no luck
I cant use any commands on the UG4 if it doesnt connect with the proxmark
I had to push down slightly on the PM3 to get it a tiny bit closer and it worked.
Post some photos of your proxmark3… did you buy it from DT or elsewhere?